HP 5100 Service Manual - Page 155
Depress the solenoid arm, and slide the gear into place. Press the gear into the plastic collar
UPC - 808736092500
View all HP 5100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 155 highlights
To reinstall 1 Tip the printer back, so that the front faces up. 2 Insert the shaft into the fitting on the right side. Then, angle the shaft into the other side. 3 Place the bushing on the right end of the shaft, and push until the tab locks in the indentation on the shaft. 4 Facing the left side of the printer, orient the shaft so that the open end of the shaft (callout 3) points away from the solenoid arm. 5 Depress the solenoid arm, and slide the gear into place. Press the gear into the plastic collar until it locks in place. 6 Reinstall the spring on the arm of the gear. 32 Figure 86. Reinstallation of Tray 2 shaft Q1860-90918 6 Removing and replacing parts 153
Q1860-90918
6 Removing and replacing parts
153
To reinstall
1
Tip the printer back, so that the front faces up.
2
Insert the shaft into the fitting on the right side. Then, angle the shaft into the other side.
3
Place the bushing on the right end of the shaft, and push until the tab locks in the indentation
on the shaft.
4
Facing the left side of the printer, orient the shaft so that the open end of the shaft (callout 3)
points away from the solenoid arm.
5
Depress the solenoid arm, and slide the gear into place. Press the gear into the plastic collar
until it locks in place.
6
Reinstall the spring on the arm of the gear.
Figure 86.
Reinstallation of Tray 2 shaft
2
3