HP 5100 Service Manual - Page 196

Table 32. Printer messages Message Explanation or recommended action EIO n DISK INITIALIZING The disk accessory card takes a long time to initialize. The first parameter is the accessory slot number for this disk accessory card. EIO n DISK NOT FUNCTIONAL The EIO disk is not working correctly. Remove the EIO disk from the slot indicated. Reseat the EIO disk. If the message continues, install a new EIO disk. EIO n INITIALIZING alternates with DO NOT POWER OFF Wait for the message to disappear (approximately 5 minutes). If the printer EIO card is operating correctly and communicating with the network, this message disappears after approximately one minute and no action is required. If the EIO card is unable to communicate with the network, this message remains for five minutes and then disappears. In this case the printer is not communicating with the network (even though the message is no longer present). The problem might be a bad EIO card, a bad cable or connection on the network, or a network problem. Contact the network administrator. EIO n DISK SPINNING UP The disk accessory card takes a moment to "spin up." The first parameter is the accessory slot number for this accessory card. FLASH n INITIALIZING alternates with DO NOT POWER OFF The flash DIMM can take a long time to initialize the first time that it is used. FLASH DEVICE FAILURE The flash DIMM had a critical failure and no longer can be used. Remove the flash DIMM and replace it with a new one. FLASH FILE The requested operation could not be performed. You might have attempted an OPERATION FAILED illegal operation, such as trying to download a file to a non-existent directory. FLASH FILE SYSTEM IS FULL Delete files from the flash DIMM or add another one. Download or delete files using HP Jetdirect, and download or delete fonts. (See the software help for more information.) FLASH IS WRITE PROTECTED The flash DIMM is protected, and no new files can be written to it. Disable the write protection through HP Jetdirect. INPUT DEVICE CONDITION xx.yy An input paper-handling device has a condition that needs attention before printing can resume. For assistance, see the documentation that came with the paper-handling device. INSTALL TONER CARTRIDGE The toner cartridge has been removed and must be replaced for printing to continue. INSTALL TRAY x The printer is unable to print the current job, because the specified tray (x) is open or not inserted correctly. Reinsert the specified tray. LOADING PROGRAM alternates with DO NOT POWER OFF Programs and fonts can be stored on the printer's file system. At startup, these entities are loaded into RAM. (These entities can take a long time to load into RAM depending on the size and number of entities being loaded.) The specifies a sequence number that indicates that the current program is being loaded. MANUALLY FEED [TYPE] [SIZE] Load the requested print media into Tray 1. Press [GO] if the media you want is already loaded in Tray 1. Press [-VALUE+] to scroll through the available types and sizes. Press [SELECT] to accept an alternative type or size. MEMORY FULL STORED No memory is available in the printer. The current job might not print correctly and DATA LOST some resources (such as downloaded fonts or macros) might have been deleted. You might want to add more memory to the printer (see page 107). 194 Troubleshooting Q1860-90918