HP 5100 Service Manual - Page 56

Table 20. Configuration menu Item Values CLEARABLE JOB WARNINGS=JOB ON AUTO CONTINUE= ON ON OFF TONER LOW=CONTINUE CONTINUE STOP JAM RECOVERY= AUTO AUTO ON OFF MAINTENANCE OFF MESSAGE=OFF SMALL PAPER SPEED=NORMAL NEW TONER CARTRIDGE =NO QUICK COPY JOBS=32 JOB HELD TIMEOUT=OFF NORMAL SLOW YES NO 1 to 50 OFF 1 HOUR 4 HOURS 1 DAY 1 WEEK Explanation Set the amount of time that a clearable warning appears on the printer control panel. JOB: Warning messages appear on the control panel until the end of the job from which they were generated. ON: Warning messages appear on the control panel until [Go] is pressed. Determine how the printer reacts to errors. ON: If an error occurs that prevents normal printing, the message appears, and the printer will go offline for 10 seconds before returning online. OFF: If an error occurs that prevents printing, the message will remain on the display and the printer will remain offline until [Go] is pressed. If the printer is on a network, you will probably want to turn AUTO CONTINUE to ON. Note: This setting has no effect on some errors that prevent normal printing, such as jams. Determine how the printer behaves when toner is low. The TONER LOW message first appears when the toner cartridge is almost out of toner. (About 100 to 300 sheets can still be printed.) CONTINUE: The printer continues to print while the TONER LOW message appears. STOP: The printer goes offline and waits for further action. Determine how the printer behaves when a jam occurs. AUTO: The printer automatically selects the best mode for printer jam recovery (usually ON). This is the default setting. ON: The printer automatically reprints pages after a jam is cleared. OFF: The printer does not reprint pages after a jam is cleared. Printing performance might be increased with this setting. This item appears only after the PERFORM PRINTER MAINTENANCE message appears. OFF: The PERFORM PRINTER MAINTENANCE message is cleared and will not be appear again until the next maintenance is due. The message should not be turned off unless the printer maintenance has been performed. If the required maintenance is not performed, the printer's performance will decline. Sets the speed with which smaller-sized media passes through the printer. This item allows the user to tell the printer that a new print cartridge has been installed. Setting this item to YES resets the HP TonerGauge to full. Specifies the number of quick-copy jobs that can be stored on the printer hard disk. Sets the amount of time that quick-copy, proof-and-hold, private, and stored jobs are kept before being automatically deleted from the queue. 54 Printer operation Q1860-90918