HP LH4r HP Netserver LP 1000r User Guide - Page 15
Opening and Closing the HP, Netserver
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
2 Opening and Closing the HP Netserver Introduction This chapter describes how to the remove the top cover, front bezel, and the air duct from the HP Netserver LP 1000r. WARNING Before removing the top cover, always disconnect the power cord and unplug telephone cables. Disconnect the power cord to avoid exposure to high energy levels that may cause burns when parts are short-circuited by metal objects, such as tools or jewelry. Disconnect telephone cables to avoid exposure to shock hazard from telephone ringing voltages. Tools Required The following tool may be needed to remove the air duct for the first time: • ¼-inch flat blade screwdriver (for the air duct) Removing the Front Bezel The front bezel is provided to protect the power and reset switches from accidental disabling. To remove the front bezel, follow these steps: NOTE You do not need to removal the front bezel to remove the top cover of the Netserver. You do need to remove the front bezel to install mass storage devices or media. 1. If the Netserver is operating, you do not need to turn off power to remove the front bezel. 2. Release the front bezel by placing your hand at the center of the half-moon opening in center of the front bezel. See Figure 2-1. 3. Pull out towards you on the front bezel. The bezel rotates down to approximately an 80° angle. 9