HP LH4r HP Netserver LP 1000r User Guide - Page 66
Tools Required
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 66 highlights
Chapter 7 Rack Mounting the HP Netserver (2-Post) NOTE If you want to mount your Netserver in a third-party rack not mentioned in this guide, you may find relevant documentation on HP's web site at the following URL: http://www.hp.com/netserver/support Before mounting the Netserver, determine the Netserver's location in the rack relative to other rack components. The HP Netserver LP 1000r rack mounting kit only requires one EIA unit of space in the rack. Proper placement is vital both for safety and operating efficiency. For more information, refer to "Rack Configuration Tools" later in this chapter. NOTE If the HP Netserver is completely configured by the vendor before delivery to the customer, then mounting the HP Netserver in the rack may be the final step in the installation procedure. If the vendor configures the HP Netserver at the customer's site, installation of the network operating system and other software may occur after the HP Netserver is mounted in the rack. WARNING The HP Netserver weighs 32 lbs. (14.5 kg.) fully loaded. To prevent an accident, use two people when placing the Netserver into the rack. CAUTION If other rack components are to be mounted in the rack below the HP Netserver, install those components before starting to mount the Netserver. Tools Required To assemble the rack mount kit and install the HP Netserver on it, you need these tools. • T-15 Torx Driver (Bracket mounting) • Number 2 Phillips screwdriver (Rack mounting) • Masking tape or marking pen 60