HP LH4r HP Netserver LP 1000r User Guide - Page 84
Anti-tip Foot, Extended, Leveler, Screws 4
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 84 highlights
Chapter 8 Rack Mounting the HP Netserver (4-Post) Leveler Screws (4) Anti-tip Foot Extended Figure 8-4. Mounting Outer-Rails to Columns 4. Match the outer-rail pins to the column holes (1st & 3rd) marked on the front and rear columns. See Figure 8-3. The mounting pins of the outer-rails should go into the inside face of the rear column and the front face of the front column. 5. With the outer-rail assembly held in position at the rear, push in on the front outer-rail mount and place in the two holes in the front column face. A tension spring allows the outer-rails to compress during installation. The outer-rails are held in place at of the front of the rack by a flat spring tab at the rear face of the front columns. See Figures 8-2 and 8-5. 78