HP LH4r HP Netserver LP 1000r User Guide - Page 48
When you have completed the PCI aboard installation, close the Netserver
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
Chapter 5 Latch Installing Additional Boards Riser Board Installed PCI Slot Figure 5-5. Inserting PCI Board-Riser Board 12. Insert the PCI board and riser board into the PCI connector on the system board. See Figure 5-5. 13. Secure the PCI board into the slot opening between the two tabs and close the latch. See Figures 5-4 and 5-5. 14. If you have a longer PCI board, you must use the board clamp to install the board into the Netserver. See Figure 5-6. a. Raise the board clamp before installing the PCI board. See Figure 5-6. b. Install the PCI board into the Netserver, securing the PCI board into the slot opening between the two tabs. See Figures 5-4 and 5-5. c. Lower the PCI board onto the tab rests. See Figure 5-6. d. Close the latch and then close the board clamp onto the edge of the PCI board. See Figure 5-6. 15. When you have completed the PCI aboard installation, close the Netserver and return it to the rack where power can be applied. 42