HP LH4r HP Netserver LP 1000r User Guide - Page 36
System Board top view, Slots
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
Chapter 4 Installing Additional Memory 0 1 DIMM 2 Slots 3 System Board (top view) Figure 4-2. DIMM Locations on System Board 7. Choose an empty slot on the system board to install a DIMM. DIMMs may be installed in any combination, in any slot, but HP recommends starting at slot 0 and filling the slots in order with the largest size first: DIMM slots 0, 1, 2, and 3. 8. Spread the two retaining latches on the slot outward. See Figure 4-3. CAUTION The memory modules are sensitive to static electricity and can be easily damaged by improper handling. Do the following when handling the accessory kit: • Leave the memory module in the anti-static container until you are ready to install it. • Always use an anti-static wrist strap and a grounding mat. • Before you remove a memory module from the anti-static container, touch a grounded, unpainted metal surface on the HP Netserver to discharge static electricity. 30