HP LH4r HP Netserver LP 1000r User Guide - Page 95

Chapter 10 Configuring the HP Netserver under Embedded LAN Controllers in the LAN A submenu (Configuration > Embedded LAN Controllers > LAN A). You must also install the Netserver Agent software from the HP Netserver Navigator CD-ROM, and the AOL2 client software. Refer to the Netserver Alert-On-LAN 2 User Guide available online on the HP Netserver Online Documentation CD-ROM included with your system. DiagTools This utility provides an easy-to-use hardware diagnostic for Netserver verification, burn-in, and rapid troubleshooting. It must first be copied to diskettes and then executed from the diskettes. NOTE HP recommends using the HP DiagTools utility to verify all Netserver functions are operating correctly, after completing all the configuration topics. The HP DiagTools utility also generates a text file containing the hardware detected and the DiagTools test results. This text file, called a support ticket, should be saved to a diskette and used for future reference, especially by your support provider. Setup (BIOS) Utility The HP Netserver (BIOS) Setup Utility is used to configure the following Netserver options: • User Preferences • Security • Configuration • Exit Accessing the Setup Utility The (BIOS) Setup Utility menu offers the choices listed above, and the corresponding items are described in the topics below. 1. Turn on the monitor and the HP Netserver. 2. Start the Setup Utility by pressing the [F2] key, when the following message appears on the boot screen. Press to enter SETUP 89