HP LH4r HP Netserver LP 1000r User Guide - Page 85
View Rotated 90 Degrees CCW, Spring Tab
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 85 highlights
Chapter 8 Rack Mounting the HP Netserver (4-Post) 6. Repeat Steps 3 through 5 for the outer-rail on the right front and rear columns. 7. If you need to release the outer-rail assembly once it is installed into the rack, do the following: a. Place your finger inside the rail at the point shown by the arrow to release the spring tab. See Figure 8-5. b. Press in on the spring tab and pull the outer-rail assembly toward you at the front of the rack. See Figure 8-5. Spring Tab View Rotated 90 Degrees CCW Figure 8-5. Releasing the Outer-Rail Assembly 79
Chapter 8
Rack Mounting the HP Netserver (4-Post)
79
6.
Repeat Steps 3 through 5 for the outer-rail on the right front and rear
columns.
7.
If you need to release the outer-rail assembly once it is installed into the
rack, do the following:
a.
Place your finger inside the rail at the point shown by the arrow to
release the spring tab. See Figure 8-5.
b.
Press in on the spring tab and pull the outer-rail assembly toward you at
the front of the rack. See Figure 8-5.
View Rotated 90 Degrees CCW
Spring Tab
Figure 8-5. Releasing the Outer-Rail Assembly