HP LH4r HP Netserver LP 1000r User Guide - Page 45
Connector, System Board top view, Bit PCI Slot 1, Riser Board not shown
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
Chapter 5 Installing Additional Boards 64-Bit PCI Slot (1) Riser Board (not shown) I2C Connector System Board (top view) Figure 5-2. PCI Accessory Board Slot NOTE Refer to "System Board Layout" in the Appendix A, "Specifications," for connections not shown in Figure 5-2. 7. Lift and rotate the securing clamp up to about a 45° angle. See Figure 5-3. The securing clamp holds the riser board in place and helps secure the PCI board. 8. Remove the securing clamp from the chassis and set it aside for re-assembly later. 39
Chapter 5
Installing Additional Boards
39
IC
Connector
2
System Board (top view)
64-Bit PCI Slot (1)
Riser Board (not shown)
Figure 5-2. PCI Accessory Board Slot
NOTE
Refer to "System Board Layout" in the Appendix A,
"Specifications," for connections not shown in Figure 5-2.
7.
Lift and rotate the securing clamp up to about a 45
°
angle. See Figure 5-3.
The securing clamp holds the riser board in place and helps secure the PCI
board.
8.
Remove the securing clamp from the chassis and set it aside for
re-assembly later.