HP LH4r HP Netserver LP 1000r User Guide - Page 83
Attaching the Outer-Rail Assemblies
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 83 highlights
Chapter 8 Rack Mounting the HP Netserver (4-Post) 2. Use the masking tape (or marking pen) to mark above the 3rd hole up on both front columns, as shown in Figure 8-3. Rear of Rack # "#" represents the EIA unit numbers on the rack columns. 3rd Hole From Bottom 1st Hole From Bottom # # Masking Tape # Marker Left Side # # Bottom of HP NetServer Mark this face of the columns with masking tape or marker pen. Front of Rack Figure 8-3. Location Marks on the Rack's Columns Right Side 3. Mark the inside face of the left-rear and right-rear rack columns as shown in Figure 8-3. Attaching the Outer-Rail Assemblies No tools are required to attach the outer-rail assemblies to the rack columns. 1. Pull the anti-tip foot forward out of the bottom of the rack. See Figure 8-4 for the anti-tip foot location. 2. Lower the leveler screws on the rack's lower four corners to make firm contact with the floor. See Figure 8-4. 3. Align the left outer-rail to the left front and rear columns as shown in Figure 8-4. 77