HP LH4r HP Netserver LP 1000r User Guide - Page 79

Chapter 8 Rack Mounting the HP Netserver (4-Post) NOTE If the HP Netserver is completely configured by the vendor before delivery to the customer, then mounting the HP Netserver in the rack may be the final step in the installation procedure. CAUTION If other rack components are to be mounted in the rack below the HP Netserver, install those components before starting to mount the Netserver. Tools Required This rack mounting kit is provided as a tool-less assembly, but does need a nut drive or wrench to release the spring mechanism after shipping. • Nut driver (10-mm) or wrench (release spring mechanism after shipping) • Masking tape or marking pen Rack Configuration Tools The HP rack configuration tools, including white papers, are available on the worldwide web at HP's web site. Enter the following URL in your browser: http://www.hp.com/netserver At the Web site, search for "configuration tools" and "high density rack solutions", specifically Rack Assistant, Rack Configuration, Order Assistant, and HP Netserver High Density Rack Solutions Overview (LP 1000r and LP 2000r). You can read about the tools or download copies for installation. These tools can be used to plan a rack configuration for the components in your system. The white papers, specifically HP Netserver High Density Rack Solutions Overview (LP 1000r and LP 2000r), provide rack information for HP Netservers in the high density racks and additional information for rack systems not listed in this manual. You will need this information to complete a rack system installation. 73