HP rp3440 Installation Guide, Seventh Edition - HP 9000 rp3410 and HP 9000 rp3 - Page 21
Rear View, Table 1-5, Rear Panel Connectors and Switches, Connector/Switch, Function - end support
View all HP rp3440 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Figure 1-9 Rear View VGA Port-disabled DO NOT USE ac Power Receptacle LVD/SE SCSI 10/100 iLO MP LAN 10/100/1000 LAN Installing the System Introduction System Lock Console/Remote/UPS Console/Serial Port A (factory use only) USB Ports TOC Button Serial Port B (factory use only) PCI Slot 1 PCI Slot 2 PCI Slot 3 (rp3440 only) PCI Slot 4 (rp3440 only) Locator Button and LED Table 1-5 lists the rear-panel connectors and switches. Table 1-5 Rear Panel Connectors and Switches Connector/Switch Function ac power LVD/SE SCSI Primary power connection for the server. 68-pin, low-voltage differential, single-ended U160 SCSI. This connector provides external SCSI connection on SCSI Channel B. (1 GB) 10/100/1000 LAN Serial A (console) and Serial B USB TOC Locator button and LED Video (not used) Console/remote/UPS 10/100 iLO MP LAN 10/100/1000 base-T ethernet LAN connector. 9-pin male serial connectors-factory use only. Four universal serial bus (USB 2.0) connectors. Transfer of control button. Halts all system processing and I/O activity and restarts system. The locator button and LED are used to help locate a server within a rack of servers. When the button is engaged, the blue LED illuminates and an additional blue LED on the front panel of the server illuminates. You can remotely activate this function. 15-pin female video connector. DISABLED-DO NOT USE. To enable video capability you must obtain the supported A6150 video PCI card. See enclosed ReadMe, A6150-90001. 25-pin female serial data bus connector for the iLO MP card. 10 Mb/100 Mb LAN connector for the iLO MP. Chapter 1 21