HP rp3440 Installation Guide, Seventh Edition - HP 9000 rp3410 and HP 9000 rp3 - Page 80
Powering ON and Powering OFF, Power States
View all HP rp3440 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 80 highlights
Installing the System Powering ON and Powering OFF IMPORTANT The server console output does not display on the console device screen until the server boots to the BCH Main Menu. Start a console session using the RS-232 serial port method to view console output prior to booting to the BCH Main Menu or to access the iLO MP. To access the graphic console with VGA, follow these steps: Step 1. Connect the monitor, keyboard, and mouse cables. a. Connect the monitor VGA cable to the appropriate VGA port on the server. b. Connect the keyboard USB cable to the appropriate USB port on the server. c. Connect the mouse USB cable to the appropriate USB port on the server. Step 2. Power on the server. The BCH Main Menu prompt displays. Powering ON and Powering OFF This section provides information and procedures for powering on and powering off the server. Power States The server has three power states: • Standby power • Full power • Off Plug the power cord into the appropriate receptacle on the rear of the server to achieve the standby power state; the front panel power button is not turned on. Full power occurs when the power cord is plugged into the appropriate receptacle, and either the power is activated through the iLO MP PC command, or the power button is activated. In the off state, the power cords are not plugged in. Table 1-11 lists the server power states. Table 1-11 Power States Power States Power Cable Plugged Into Receptacle? Power Activated through the iLO MP PC Command; or Front Panel Power Button Activated? Standby dc Voltage Applied? dc Voltage Applied? Standby power Yes No Full power Yes Yes Off No No Yes No Yes Yes No No 80 Chapter 1