HP rp3440 Installation Guide, Seventh Edition - HP 9000 rp3410 and HP 9000 rp3 - Page 57

Aligning the Processor Module, Step 7.

Get HP rp3440 PDF manuals and user guides View all HP rp3440 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 57 highlights

Installing the System Installing Additional Components NOTE Protective covers can be installed to protect connector pins. These covers can be saved for future use. Step 7. Use the four locator posts on the heatsink and the turbo fan power cable to properly align the fan and dual processor module on the system board. The four locator posts will fit in locator holes on the system board processor module mount. The turbo fan power cable must be positioned so that it is located on the side of the heatsink that faces the front of the server. Figure 1-43 Aligning the Processor Module Step 8. Use the special CPU install tool (2.5 mm driver or Allen Wrench) to lock the dual processor module in place on the system board. To do this, insert the CPU install tool into the hole that runs down the side of the heatsink and rotate it clockwise 180 degrees. Chapter 1 57

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
Installing the System
Installing Additional Components
Chapter 1
57
NOTE
Protective covers can be installed to protect connector pins. These covers can be
saved for future use.
Step 7.
Use the four locator posts on the heatsink and the turbo fan power cable to properly align the fan
and dual processor module on the system board. The four locator posts will fit in locator holes on
the system board processor module mount. The turbo fan power cable must be positioned so that it
is located on the side of the heatsink that faces the front of the server.
Figure 1-43 Aligning the Processor Module
Step 8.
Use the special CPU install tool (2.5 mm driver or Allen Wrench) to lock the dual processor module
in place on the system board. To do this, insert the CPU install tool into the hole that runs down the
side of the heatsink and rotate it clockwise 180 degrees.