HP rp3440 Installation Guide, Seventh Edition - HP 9000 rp3410 and HP 9000 rp3 - Page 29

Replacing the Front Bezel on a Rack-Mounted Server

Page 29 highlights

Installing the System Installing Additional Components Step 2. Rotate the front panel outward and lift it off the server chassis. Replacing the Front Bezel on a Rack-Mounted Server Step 1. Insert the bezel latches into the matching slots on the server chassis. Step 2. Close the bezel and push toward the front of the server until it locks into place. Figure 1-15 Replacing the Front Bezel Accessing a Pedestal-Mounted Server NOTE If you are replacing a hot-swappable item, you can leave the server on and external cables (including the power cord) connected. Removing the Side Cover on a Pedestal-Mounted Server Step 1. Power off the server and disconnect the power and external cables. Step 2. Remove the side cover. a. Grasp both indentations at the top of the side panel and pull outward. b. Lift the side cover off of the server chassis. Chapter 1 29

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96

Installing the System
Installing Additional Components
Chapter 1
29
Step 2.
Rotate the front panel outward and lift it off the server chassis.
Replacing the Front Bezel on a Rack-Mounted Server
Step 1.
Insert the bezel latches into the matching slots on the server chassis.
Step 2.
Close the bezel and push toward the front of the server until it locks into place.
Figure 1-15
Replacing the Front Bezel
Accessing a Pedestal-Mounted Server
NOTE
If you are replacing a hot-swappable item, you can leave the server on and external cables
(including the power cord) connected.
Removing the Side Cover on a Pedestal-Mounted Server
Step 1.
Power off the server and disconnect the power and external cables.
Step 2.
Remove the side cover.
a.
Grasp both indentations at the top of the side panel and pull outward.
b.
Lift the side cover off of the server chassis.