HP rp3440 Installation Guide, Seventh Edition - HP 9000 rp3410 and HP 9000 rp3 - Page 38

Hard Drive Lock, Step 6. - mp commands

Get HP rp3440 PDF manuals and user guides View all HP rp3440 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 38 highlights

Installing the System Installing Additional Components a. Press the hard drive locking lever down into the locked position. b. Replace the cover and bezel. (See "Removing and Replacing Server Covers and Bezels" on page 25.) Figure 1-26 Hard Drive Lock Step 6. Verify the drive installation by using the system utilities. • Use the iLO MP commands to verify operation. • Use the BCH commands to verify operation. • Use diagnostics provided by the offline diagnostic environment to exercise the module added. Step 7. If rack-mounted, slide the server back into the rack until it stops. Step 8. Check the installation of the hard disk drive by powering on the server and checking the virtual front panel and system event log for correct status for the hard disk drive. 38 Chapter 1

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
Installing the System
Installing Additional Components
Chapter 1
38
a.
Press the hard drive locking lever down into the locked position.
b.
Replace the cover and bezel. (See “Removing and Replacing Server Covers and Bezels” on
page 25.)
Figure 1-26 Hard Drive Lock
Step 6.
Verify the drive installation by using the system utilities.
•
Use the iLO MP commands to verify operation.
•
Use the BCH commands to verify operation.
•
Use diagnostics provided by the offline diagnostic environment to exercise the module added.
Step 7.
If rack-mounted, slide the server back into the rack until it stops.
Step 8.
Check the installation of the hard disk drive by powering on the server and checking the virtual
front panel and system event log for correct status for the hard disk drive.