HP rp3440 Installation Guide, Seventh Edition - HP 9000 rp3410 and HP 9000 rp3 - Page 53
Installing a PCI Card, Installing a PCI Card - backplane
View all HP rp3440 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 53 highlights
Installing the System Installing Additional Components Failure to observe this warning can result in personal injury or damage to equipment. CAUTION Observe all ESD safety precautions before attempting this procedure. Failure to follow ESD safety precautions can result in damage to the server. Carefully read the following information concerning PCI slot configuration. Inserting a PCI card into a slot that is not configured to accept it can cause operation failure or the PCI card to operate at less than optimum speed. PCI slots are numbered 1 (top of card cage) through 4 (bottom of card cage). See the labels on the rear panel of the chassis for correct PCI slot number identification. Installing a PCI Card Step 1. Remove the cover. (See "Removing and Replacing the Top Cover on a Rack-Mounted Server" on page 26.) Step 2. Remove the PCI cage. (See "Removing the PCI Card Cage" on page 50.) Step 3. Grasp the edges of the PCI card to be installed and evenly press the card into the PCI backplane connector. Figure 1-39 Installing a PCI Card Step 4. Connect any internal cables that are required by the PCI card. Step 5. Install the accessory card holder(s) and secure in place by tightening the associated bulkhead screw(s). Step 6. Reinstall the PCI cage. (See "Replacing the PCI Card Cage" on page 52.) Step 7. Replace the cover. (See "Removing and Replacing the Top Cover on a Rack-Mounted Server" on page 26.) Chapter 1 53