HP t150 Maintenance & Service Guide: HP MultiSeat 6000 Desktop, HP MultiSe - Page 80
Removing and Replacing the Primary 3.5-inch Internal SATA Hard, Drive, Rotating the Drive Cage Up
View all HP t150 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 80 highlights
Removing and Replacing the Primary 3.5-inch Internal SATA Hard Drive NOTE: The system does not support Parallel ATA (PATA) hard drives. Before you remove the old hard drive, be sure to back up the data from the old hard drive so that you can transfer the data to the new hard drive. The preinstalled 3.5-inch hard drive is located under the power supply. To remove and replace the hard drive: 1. Prepare the computer for disassembly (Preparation for Disassembly on page 42). 2. Remove the access panel (Access Panel on page 43). 3. Rotate the drive cage for external drives to its upright position. Figure 6-31 Rotating the Drive Cage Up 70 Chapter 6 Removal and Replacement Procedures
Removing and Replacing the Primary 3.5-inch Internal SATA Hard
Drive
NOTE:
The system does not support Parallel ATA (PATA) hard drives.
Before you remove the old hard drive, be sure to back up the data from the old hard drive so that you
can transfer the data to the new hard drive.
The preinstalled 3.5-inch hard drive is located under the power supply. To remove and replace the
hard drive:
1.
Prepare the computer for disassembly (
Preparation for Disassembly
on page
42
).
2.
Remove the access panel (
Access Panel
on page
43
).
3.
Rotate the drive cage for external drives to its upright position.
Figure 6-31
Rotating the Drive Cage Up
70
Chapter 6
Removal and Replacement Procedures