IBM 847651U Handbook - Page 120

Working with adapters Installing or removing AGP adapters This section gives the procedure for installing an AGP adapter in the dedicated AGP slot connector. If you want to remove an AGP adapter from this slot connector, reverse the order of the following steps. If you need to install an adapter in an ISA or PCI slot connector, go to "Installing or removing ISA and PCI adapters" on page 82. Notes: 1. You may install a video adapter in the dedicated AGP slot connector, in an ISA slot connector, or in a PCI slot connector. However, the server system board does not support the AGP video connector and the integrated video subsystem simultaneously. 2. You can install only a special AGP graphics adapter in the dedicated AGP slot connector. For information on the available AGP adapters, go to http://www.ibm.com/pc/us/compat/ on the World Wide Web. Before you begin: Read "Electrical safety" on page 70 and "Handling static-sensitive devices" on page 71. Read the documentation that comes with the option. Read "Accessing the system board" on page 78. Attention: The presence of 5 V ac standby power might result in damage to your hardware unless you disconnect the power cord from the electrical outlet before you open the server. To install an AGP adapter: 1. Remove the server side cover (see "Disconnecting cables and removing the side cover" on page 74). 2. Remove the screw; then, remove the cover to access the two slots on the server wall. The slots on the server wall provide 86 Netfinity 3000 User's Handbook