IBM 847651U Handbook - Page 165

Working with microprocessors 5. Press the microprocessor into the connector until it snaps into place and is fully seated in the connector. 6. If the microprocessor has tabs at the upper corners instead of an adapter with a handle, pull outward on the retainer tabs to secure the microprocessor in place. 7. If you replace the microprocessor with one that has a different speed, you must change the switch settings on the system board. To locate the switches, see "System Board Illustration" on page 253. For information about the appropriate switch settings, see "Setting the microprocessor speed switches" on page 258, or see the label inside the server side cover. 8. Go to Table 14 on page 246 to update the microprocessor information; then, return here. 9. If you receive the error code 167 after you install a new microprocessor, run the Flash Utility program. Insert the Flash Chapter 4. Installing options 131