IBM 847651U Handbook - Page 71

The Configuration/Setup Utility program POST Startup Error(s) The following error(s) were detected when the system was started: 162 Configuration Change Has Occurred Select one of the following: Continue Exit Setup Note: Depending on the configuration changes that occurred, the error message that you see might be different from the one shown here. If the preceding screen appears, select Continue until you reach the Configuration/Setup Utility program menu; then, go to "Using the Configuration/Setup Utility program" on page 39. If the preceding screen does not appear, use the following procedures to access the Configuration/Setup Utility program menu. To start the Configuration/Setup Utility program: 1. Turn on the server and watch the screen. If your server is already turned on, turn off the server, wait a few seconds until all in-use lights go off, and then turn the server back on. (Do not use Ctrl+Alt+Del to restart the server.) 2. When the message Press F1 to enter Configuration/Setup appears, press F1. The Configuration/Setup Utility program menu appears. For information about the menus, see "Using the Configuration/Setup Utility program" on page 39. Chapter 3. Configuring your server 37