IBM 847651U Handbook - Page 230

Ethernet controller messages Ethernet controller messages Note: The error messages shown in this section are available only with the integrated Ethernet controller. These error messages are not available when remote program load (RPL) or dynamic host configuration protocol (DHCP) is used through optional network adapters. If a failure condition occurs after the Ethernet controller is initialized, an error message appears on the screen. The error messages that can occur are shown in the following sections. If you experience any error related to the integrated Ethernet controller, record the error message, and tell your network administrator about the problem. The two most common error messages are: RPL-ROM-ERR: 1 5 The integrated Ethernet failed the loopback test. RPL-ROM-ERR: 1 7 The media test failed. Error 105 indicates that a power-on diagnostic test performed by the Ethernet module did not execute correctly. If this error message appears, you must have the server serviced. Error 107 indicates that the cable from the LAN is not securely connected to the Ethernet port on your server. Check the cable to ensure that it is properly connected. Other error messages that might occur are shown in Table 11 on page 197. Note: An x value that follows an error code represents any alphanumeric character. 196 Netfinity 3000 User's Handbook