IBM 847651U Handbook - Page 204

POST Messages POST message 110 111 114 151 161 Description A memory parity failure occurred during testing of the system board. Action: Run the diagnostic programs to verify that a problem exists in a DIMM. (See "Running the diagnostic test programs" on page 164 for information on running the diagnostic programs that come with your server.) See "Working with memory modules" on page 96 if you need to reconfigure the system memory to aid in identifying the defective DIMM. If this procedure does not help you to identify the defective DIMM, have the system serviced. An adapter read-only memory (ROM) error occurred. Action: Remove all adapters that are not required for system startup and reinstall them one at a time, powering on after each is reinstalled. When this message displays, replace the adapter that you just installed. If you cannot isolate and correct the problem, have the system serviced. A real-time clock (RTC) error occurred. Action: Have the system serviced. The battery on the system board is dead. Attention: Follow the instructions in the battery-safety statement in "Replacing the battery" on page 224. Action: Replace the battery. For additional information on battery use, disposal, and replacement, see "Lithium battery notice" on page xxv and "Replacing the battery" on page 224. You can use the server until you replace the battery. However, you must run the Configuration/Setup Utility program and set the time and date each time that you turn on the server, until you install a new battery. (For instructions on using the Configuration/Setup Utility program, see "Using the Configuration/Setup Utility program" on page 39.) 170 Netfinity 3000 User's Handbook