IBM 847651U Handbook - Page 162

Working with microprocessors Notes: 1. The microprocessor in your server comes with an attached heat sink. The microprocessor plugs into the microprocessor socket on the system board and is stabilized with a plastic bracket attached to the system board. The type of heat sink in your server might be different from the heat sink shown in this section. 2. To locate the microprocessor switch area of the system board, find the rocker switches section of the system-board illustration. See "System Board Illustration" on page 253. For information about the appropriate switch settings, see "Setting the microprocessor speed switches" on page 258, or see the label inside the server. To install a microprocessor: 1. Remove the server side cover (see "Disconnecting cables and removing the side cover" on page 74). 2. Remove the existing microprocessor from its socket. a. Locate the microprocessor socket on the system board. (See the illustration in "System Board Illustration" on page 253.) b. Grasp the middle of the microprocessor adapter 1 and pull straight up, lifting the microprocessor out of the connector 2 . 128 Netfinity 3000 User's Handbook