IBM 847651U Handbook - Page 295

Attention: Processors 450 MHz and higher automatically set the processor speeds. Locate in the table the microprocessor speed and front side bus speed the microprocessor is rated for, then make sure the jumper switches are set as shown. Notes: a. Visit http://www.ibm.com/netfinity (Server Tech Library/Configuration Tools or equivalent selection) to determine which microprocessor upgrade can be used on your model of Netfinity 3000. b. For jumper settings for other speed microprocessors, refer to the label inside the cover of your server. 3. If you receive the error code 167 after you install a new microprocessor, run the Flash Utility program. Insert the Flash BIOS Diskette into the primary diskette drive and run the flash program. Follow the instructions in the program. For additional information on error code 167, see the description in the "POST message table" on page 169. 4. After changing configuration switch settings, you must reconfigure the server. After reassembling the server (see "Completing the installation" on page 148), use the Configuration/Setup Utility program to reconfigure the server. For more information, see "Using the Configuration/Setup Utility program" on page 39. Chapter 7. Server records and specifications 261