IBM 847651U Handbook - Page 174
SCSI connectors, Internal SCSI connector
UPC - 087944496366
View all IBM 847651U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 174 highlights
Connecting external options SCSI connectors If your server comes with a 16-bit UltraSCSI adapter installed, the information in this section about SCSI connectors applies to your server. The 16-bit UltraSCSI adapter adapter has two 68-pin, high-density connectors (one internal and one external). You can use these connectors to install internal SCSI devices in your server and to attach external SCSI devices to your server. Note: The 50-pin SCSI connector is not supported. See "SCSI drives (if your server model comes with a SCSI adapter)" on page 110 for additional information about the SCSI subsystem. Internal SCSI connector A 4-drop, 68-pin (16-bit) cable is installed in your server. This cable is connected to the internal connector for the 16-bit UltraSCSI adapter. You can use this cable to install additional SCSI devices in your server. A hard disk drive might also be installed in bay 6, depending on the model of your Netfinity 3000 server. For information about termination requirements, see "Termination requirements" on page 111. External SCSI connector You can attach external SCSI devices to the 16-bit, 68-pin external SCSI connector that is located on the rear of your server. 140 Netfinity 3000 User's Handbook