IBM 847651U Handbook - Page 82

Using the Configuration/Setup Utility program Notes: 1. If a power-on password is set and then forgotten, you must remove the server cover and move the Clear CMOS Request jumper on the system board. (See "Erasing lost or forgotten passwords" on page 254 for further information.) 2. If a power-on password is set and the password prompt is set to Off, the pointing device (mouse) is disabled until you enter the power-on password. To delete a power-on password: 1. From the Configuration/Setup Utility program menu, select System Security; then, press Enter. 2. The System Security menu appears. 3. Select Power-On Password; then, press Enter. 4. The Power-On Password menu appears. 5. Select Delete Power-On Password and follow the instructions on the screen. Using the Administrator Password menu The administrator password (sometimes called a supervisor-level password) controls access to some features of the server, including the Configuration/Setup Utility program. To set or change an administrator password: 1. From the Configuration/Setup Utility program menu, select System Security; then, press Enter. 2. The System Security menu appears. 3. Select Administrator Password; then, press Enter. 4. The Administrator Password menu appears. 5. To set an administrator password, enter your password in the appropriate data field and press the Down Arrow (↓) key. You can use any combination of up to seven characters (A-Z, a-z, and 0-9) for this password. Keep a record of the password in a safe place. 48 Netfinity 3000 User's Handbook