IBM 847651U Handbook - Page 85

Using the Configuration/Setup Utility program password is entered. This feature will work if your server is powered on or off. To enable or disable enhanced security: Note: Enhanced security can be enabled or disabled only when you update the system programs in your server. 1. Insert a Flash BIOS diskette in your server. System programs updates are available on the World Wide Web. To obtain up-to-date information about your server model, access the home page for your server at the following address: http://www.ibm.com/netfinity/ 2. Turn on the server. If it is already turned on, you must turn it off and back on again. 3. The update begins, and the system prompts you for the administrator password, if you have set an administrator password. 4. When you enter the administrator password, the Flash BIOS diskette will continue to run, and you are given the option of enabling or disabling enhanced security. To set, change, or delete an administrator password protected by enhanced security: 1. Turn off all attached devices and the server. 2. See Chapter 4, "Installing options" on page 67 for safety information, disconnecting all cables, and removing the server cover. 3. Locate the switch marked as 7 on the rocker switches section of the system board. See "Setting the administrator password switch" on page 266 for the location of the switch. Move the switch to the ON position. (It might be helpful to use the end of a small screwdriver to set the switch.) Note: You must know the administrator password to change or delete it. Chapter 3. Configuring your server 51