IBM 847651U Handbook - Page 97
Using the SCSISelect Utility program, Adapter, Send Start Unit Command, Maximum Sync Transfer Rate
UPC - 087944496366
View all IBM 847651U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 97 highlights
Using the SCSISelect Utility program Note: On this menu, the SCSI controller is referred to as the Host Adapter. This menu has the following choices: Host Adapter SCSI ID The default SCSI ID of the SCSI controller is 7. Do not change this value. SCSI Parity Checking The default value is Enabled. Do not change this value. Host Adapter SCSI Termination The default value is Automatic. Do not change this value. Boot Device Options Select this choice to configure startable device parameters. Before you can make updates, you must know the ID of the device whose parameters you want to configure. The default startup (boot) SCSI ID is 0 for an internal SCSI hard disk drive in Channel A. SCSI Device Configuration Select this choice to configure SCSI device parameters. Before you can make updates, you must know the ID of the device whose parameters you want to configure. Notes: 1. For SCSI tape drives, set Send Start Unit Command to Off for that SCSI ID. This ensures proper server operation. 2. When the Maximum Sync Transfer Rate is set to 40.0, this value represents the transfer rate for UltraSCSI devices. When this value is set to 20.0, it represents the transfer rate for Fast SCSI devices. Advanced Configuration Options Select this choice to view or change the settings for advanced configuration options. These options include enabling support for large hard disk drives and support for drives with UltraSCSI speed. Chapter 3. Configuring your server 63