IBM 847651U Handbook - Page 298
Setting the Ethernet controller operation mode switch
![]() |
UPC - 087944496366
View all IBM 847651U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 298 highlights
Setting the Ethernet controller operation mode switch When you want to change the Ethernet controller operation mode from Normal to MAC Disabled, you must change the setting of configuration switch 6. Before you begin: Read "Electrical safety" on page 70 and "Handling static-sensitive devices" on page 71. Turn off the server and all other connected devices. Disconnect all external cables attached to the server; then, remove the server cover (see "Preparing to add options" on page 73). 1. Locate the configuration switches (also known as rocker switches) on the system board. For more information, refer to the label inside the server, or see "System Board Illustration" on page 253. 2. To set the Ethernet controller operation mode to the appropriate value, set switch 6 as shown in the following illustration. It might be helpful to use the end of a small screwdriver to set the switch. Attention: The following illustration is for reference only. Before you change the settings for switch 6, be sure that you check the orientation of your server system board to correctly identify the switch number locations. If you change the settings for the wrong switches, you might seriously damage server components or options. 264 Netfinity 3000 User's Handbook
![](/manual_guide/products/ibm-847651u-handbook-778b46d/298.png)