IBM 847651U Handbook - Page 231

Ethernet controller messages Table 11 (Page 1 of 3). Ethernet controller messages Error Code Description RPL-ROM-ERR: 100 The integrated Ethernet controller cannot be found. Action: Make sure that the Ethernet controller is enabled in the BIOS. If the problem persists, have the system serviced. RPL-ROM-ERR: 101 The integrated Ethernet controller was unable to initialize. Action: Make sure that the Ethernet controller is enabled in the BIOS. If the problem persists, have the system serviced. RPL-ROM-ERR: 102 The integrated Ethernet controller could not be reset. Action: Make sure that the Ethernet controller is enabled in the BIOS. If the problem persists, have the system serviced. RPL-ROM-ERR: 103 There are multiple Ethernet controllers or adapters in the system. Action: Specify the correct serial number in the NET.CFG file. RPL-ROM-ERR: 104 The integrated Ethernet controller EEPROM is faulty or not present. RPL-ROM-ERR: 105 The integrated Ethernet failed the loopback test. A power-on diagnostic test performed by the Ethernet module did not execute correctly. Action: Have the system serviced. RPL-ROM-ERR: 106 The integrated Ethernet controller is configured for Plug and Play in a non-Plug and Play system. RPL-ROM-ERR: 107 The media test failed. Action: The cable from the LAN is not securely connected to the Ethernet port on your server. Check the cable to ensure that it is properly connected. Chapter 5. Solving problems 197