IBM 847651U Handbook - Page 90

Using the Configuration/Setup Utility program I/O ports DMA Interrupt Note: The menus do not contain resources that are used by the system or by previously installed Plug and Play adapters. To store the legacy resource information for an installed adapter: 1. Select ISA Legacy Resources; then, use the Up Arrow (↑) or Down Arrow (↓) key to highlight the system resource that you want to change. 2. Select a resource; then, use the Left Arrow (←) or Right Arrow (→) key to select a configuration choice. If you remove an ISA legacy adapter, you must redefine the system resource as [Available]. Power Management With Power Management, the server and monitor can be set to use a reduced-power state if they are inactive for a specified length of time. You can also specify options to automatically start the server. Attention: The ACPI BIOS Mode feature is the only available Power Management feature. The APM BIOS Mode feature is set to Disabled. Do not change this default value. ACPI BIOS mode When the automatic configuration and power interface (ACPI) BIOS mode is enabled, the operating system controls the power management features of your server and the settings for APM BIOS mode are ignored. Refer to your operating-system documentation to determine if your operating system supports ACPI. If your operating system does not support ACPI, you cannot use the ACPI BIOS Mode Power Management feature. 56 Netfinity 3000 User's Handbook