Kyocera KM-C4008 C4008 Operation Guide Rev-2.0 - Page 255
OPTIONAL EQUIPMENT, Document Processor
View all Kyocera KM-C4008 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 255 highlights
Section 8 OPTIONAL EQUIPMENT Document Processor Automatically feeds and scans multiple sheet-originals one by one. Two-sided originals are automatically turned over so that both sides can be scanned and copied. Acceptable originals • Use sheet originals only • Paper weight One-sided originals: Use only originals with a paper weight of between 35 g/m² and 160 g/m². Two-sided originals: Use only originals with a paper weight of between 50 g/m² and 120 g/m². • Sizes: 5 1/2"× 8 1/2" - 11" × 17" [A5R - A3] • Number which can be set at one time 100 sheets (smaller than 11" × 8 1/2" [A4] size, between 50 g/m² and 80 g/m²) 70 sheets (larger than 8 1/2" × 14" [B4] size, between 50 g/m² and 80 g/m²) (The maximum number of originals that can be set when using the auto selection mode is 30 sheets.) Notes on acceptable documents Be sure NOT to use the following as originals in the Document Processor: • OHP film and other transparencies • Carbon paper, crumpled originals or originals with strong folds, and soft originals such as vinyl • Originals which are not rectangular, wet originals, and originals with adhesive tape or glue • Originals with clips or staples (In order to use such originals, remove the clips or staples and straighten any crumples or folds before using them. Failure to do so may cause originals to misfeed.) • Clippings or originals with very slippery surfaces • Originals with wet correction fluid • Originals with folds (If you must use such originals, smooth out the folded portions before setting them in the Document Processor. Failure to do so may cause originals to misfeed.) Names of parts (3) (2) (7)(2) (1) (5) (6) (4) (1) Original table Set originals to be copied on this table. (2) Original insert guides Align these guides to fit the width of the originals to be copied. (3) Left cover Open this cover if an original misfeed occurs. (4) Original eject table Originals that have been copied are ejected and stored here. (5) Ejection extension Open this extension when using larger sized originals such as 8 1/2" × 14" and 11" × 17" [B4 and A3]. (6) Document Processor release lever Operate this lever when you want to open the Document Processor. (7) Original set indicator Indicates the status of originals set in the Document Processor. Lit green: The originals are set properly. Copying will begin when you press the [Start] key. Blinking green: The originals need to be reset. Blinking red: An original has jammed. See page 9-16 and removed the jammed original. 8-1