Kyocera KM-C4008 C4008 Operation Guide Rev-2.0 - Page 277
Misfeed in the paper conveyor unit, High voltage is present in the charger
View all Kyocera KM-C4008 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 277 highlights
Misfeed in the paper conveyor unit If a misfeed has occurred in the paper conveyor unit, perform the following procedure to remove the jammed paper. * The following display will be displayed after you pull out the paper conveyor unit in step 2. Inch specifications Paper misfeed. JAM 1.Open right side of transfer unit and remove paper if inside. 2.Open right side of paper transfer and remove any paper. Also look in fuser & upper cover. 3.Release transfer unit lever. 4.Open transfer unit and remove paper if inside. 5.Close front cover. Metric specifications Paper misfeed. JAM 1.Remove paper if inside on the conveying unit. 2.Conveying unit right, fuser unit left and upper cover, remove paper if inside 3.Release transfer unit lever. 4.Pull out transfer unit and remove paper if inside. 5.Reset the unit and close front cover unit. 1 Open the front cover. Section 9 TROUBLESHOOTING 2 Operate the paper conveyor release lever and pull the paper conveyor unit out towards you as far as it will go. WARNING High voltage is present in the charger section. Take sufficient care when working in this area, as there is a danger of electrical shock. CAUTION The copier's fixing unit is extremely hot. Take sufficient care when working in this area, as there is a danger of getting burned. 3 Push the green release lever (shown as (1) in the illustration) down to the right, and remove the jammed paper without tearing it. (1) NOTE If the paper does happen to tear, remove any loose scraps from inside the copier. 9-9