Kyocera KM-C4008 C4008 Operation Guide Rev-2.0 - Page 270

Section 9 TROUBLESHOOTING Message Procedure Reference page "Exceeds pre registered copying quantity." The number of copies made under your department code has reached the 7-1 ["Copy limit for this ID-code has been reached. limit that was set under the copy management mode and copying is no No copying possible."] longer possible with that code. Use the copy management mode to clear the copy count. "Unable to copy.(Full-color) Exceeded the Full color copying is not available as you have reached the limit that was 7-1 limitation of management" set under the copy management function for that type of copying. To ["You cannot copy.(Full Colour) Exceeded the continue making full color copies, use the copy management function to limitation of management"] clear the corresponding copy count. "Unable to copy.(Full-color) ID-code capacity Full color copying is not available because it has been restricted. To make 7-1 has limit." full color copies, use the copy management function to change the ["You cannot copy.(Full Colour) ID-code capacity corresponding restriction. has limit."] "Paper capacity is over limited unable to copy. You are attempting use the Color/BW selection mode to make a number of --- Change preset of color or B&W selection." copies that will exceed the designated copy limit. Change the total number ["Limit of set was exceeded, can not copy. of copies to be made (both color AND black and white) to a lesser number Change preset of colour or B&W selection."] that will not exceed that copy limit. "The ID-Code is checked. Remote edit." A computer on your network is currently performing one of the "Editing --- ["The ID-Code is checked. Remote editing."] copy management information" procedures. Copying will not be possible until that operation is completed. "Set toner container." One or more of the toner containers is not set at all or is not set properly. Set the toner containers properly. There is insufficient toner left in the indicated toner container. 10-4 "Ready to copy. Toner will be empty soon.(K,C,M,Y)" You will soon need to replace the indicated toner container (C = cyan, M = magenta, Y = yellow and K = black). Make sure you have the appropriate replacement toner container ready. 10-4 "Add toner.(K,C,M,Y)" The copier has run out of toner of the color indicated. Replace the corresponding toner cartridge immediately (C = cyan, M = magenta, Y = yellow and K = black). 10-4 "Check waste toner box." • The waste toner box is full of toner. Replace the waste toner box immediately. • The waste toner box is not set properly. Set the waste toner box properly. 10-6 "Call service." Open and then close the front cover. If this message still remains, make a --- note of the number that is displayed together with the letter "C". Then, turn the power switch OFF ({), and contact your service representative or authorized service center. "System error. Main switch off / on." ["System error. Main switch Off / On."] An error has occurred. Turn the power switch OFF ({) and then back ON --- ( | ) again. "System error. Disconnect power plug from the An error has occurred. Remove the power plug from the wall outlet. --- socket." "Time for maintenance.(ABC)" Periodic maintenance is required to keep your copier in good condition. --- Contact your service representative or authorized service center immediately. The type of maintenance kit required (from A to C) will be displayed in the message area of the touch panel. "Memory full." Operation has been stopped because the copier's memory is full. Press the --- "OK" key. If the error occurred during scanning of originals, press either the "Continue" key or the "Cancel" key, as appropriate. "Continue": Copies will be made for those originals that have already been scanned. "Cancel": Delete all of the scanned data. 9-2