Kyocera KM-C4008 C4008 Operation Guide Rev-2.0 - Page 26

Section 2 NAMES OF PARTS Operation panel (19) (18) (17) (16) (15) (7) (6) (5) (4) (10) (3) (11) (22) (12) (21) (13) (14) (20) (9) (8) (2) (1) (1) [Start] key & indicator lamp Press this key when the lamp in that key is lit green and you want to start copying. (2) [Stop/Clear] key Press this key when you want to stop copying or change the number of copies to be made. (3) [Reset] key Press this key to reset all functions to their initial mode settings. (See "Initial mode (at the end of warm-up or when the [Reset] key is pressed)" on page 2-5.) (4) [Energy Saver] key & indicator lamp Press this key when you want to turn the energy-saving Low power mode ON. Press the same key again to turn the Low power mode OFF. (See page 6-86.) (5) [Interrupt] key & indicator lamp Press this key to light the lamp in that key when you want to perform interrupt copying. (See page 6-5.) (6) [Management] key When copy management is turned ON, press this key after copying in order to return to the department ID-code entry display. (See page 7-1.) (7) [Default Setting/Counter] key Press this key when you want to access default settings as well as those related to copy management, etc. (8) Keypad Use these keys when you want to set the number of copies to be made or enter other values. (9) Touch panel This panel displays such information as operation procedures, machine status, and the various function keys. (10) Brightness adjustment control dial Turn this dial when you want to adjust the brightness of the touch panel. (11) [Copier] key, lamp & indicator Press this key to light the indicator to the right of the key when you want to use the copier functions of this machine. 2-4 (12) [Printer] key, lamp & indicator Press this key when you want to use the printer functions of this machine. The indicator to the right of the key will light when the machine is in the printer operation mode. The lamp to the left of the key will either light green or orange, or will flash one of those colors, depending upon the status of the machine. (See page 9-4.) (13) [Scanner] key, lamp & indicator Press this key when you want to use the scanner functions of this machine. The indicator to the right of the key will light when the machine is in the scanner operation mode. The lamp to the left of the key will either light green or orange, or will flash one of those colors, depending upon the status of the machine. (See page 9-4.) (14) [Fax] key, lamp & indicator Press this key when you want to use the optional fax functions of this machine. The indicator to the right of the key will light when the machine is in the fax operation mode. The lamp to the left of the key will either light or flash green, depending upon the status of the machine. (15) [Auto Selection] key & indicator lamp Press this key to light the lamp in that key when you want to use the auto selection mode. The optional Document Processor must be installed in your copier in order to use this mode. (See page 8-4.) (16) [Job Build] key & indicator lamp Press this key to light the lamp in that key when you want to use the job build mode. (See page 6-86.) (17) [Repeat Copy] key & indicator lamp Press this key to light the lamp in that key when you want to use the repeat copy mode. (See page 6-49.)