Lexmark X464de Service Manual - Page 137

7014-xxx EP SETUP EP SETUP EP Defaults Fuser Temp Fuser Page Count Warm Up Time Transfer Print Contrast Normal 127 Medium Medium Submit Back The triangles pointing up or down indicate whether there are additional menus. Touch the up or down arrows to display these additional menus. Note: If you make changes, touch Submit to make the change effective. EP Defaults This setting is used to restore each printer setting listed in EP SETUP to its factory default value. Sometimes this is used to help correct print quality problems. To restore EP Defaults: 1. Touch to select EP Defaults from EP SETUP. 2. Touch to select Restore to reset the values to the factory settings, and touch Restore to exit without changing the settings. to select Do Not Touch Back to exit without changing the settings. Fuser Temperature (Fuser Temp) This adjustment can be used to help solve some customer problems with paper curl on low-grade papers and problems with letterheads on some types of media. The fuser temperature can be adjusted to: Normal, Lower, Lowest. The default is Normal. Touch Back to return to Diagnostics Menu. Fuser Page Count The fuser page count can only be viewed and cannot be changed. Touch Back to return to Diagnostics Menu. Warm Up Time You can change the amount of time the printer warms up before allowing pages to print by changing this setting from 0 to 5. The factory sets the warm up at 0 or no warm up time. This time period lets the backup roll heat up and helps reduce curl in some environments. Diagnostic aids 3-31