Lexmark X464de Service Manual - Page 51

7014-xxx Messages and error codes User attendance messages The printer control panel displays messages describing the current state of the printer and indicates possible printer problems that must be resolved. This topic provides a list of all printer messages, explains what they mean, and tells how to clear the messages. The following table lists the messages in alphanumerical order. A message can also be located using the index. User status and attendance messages User primary message Explanation Change Change Change Change This IR allows a user to override the source for the remainder of a job. The page will be printed as it is formatted on the paper installed in the tray. This may cause clipping. No further Change prompts will be posted for the remainder of the current job. The following actions can be taken: • Change the paper source to a custom type / custome string /source and size/ source, type, size. • Continue the print job. • Request more information. • Use the current source. • Reset the active. • Wait fir supplies. Close Door Message clears when front doors is closed. Disk Corrupted. Reformat? This message appears if there is a corrupted hard disk. Reformat the drive. If the message remains, replace the disk. Weblink server not setup. Web Link is being used for e-mail, and either the 'Server' or 'Web Link' fields are Contact system NULL in the Web Link Setup. administrator • The system administrator needs to configure the server. SMTP server not setup. Contact system administrator The devices primary and secondary SMTP fields are blank. This needs to be configured by the system administrator. No Analog Phone Line An analog line is not detected as being plugged into the modem. If the device is in Analog mode, this has a source of Fax. If the device is in Fax Server mode, and the 'Enable analog receive' Fax Server setting is set to 'On', this has a source of Fax Receive. If the device is in Fax Server mode and the 'Enable analog receive' Fax Server setting is set to 'Off', then this IR is not generated. Memory Full, cannot print faxes Attempted print is automatically canceled. The Fax code will recognize that the print job has been canceled and will not delete pages in the fax job that have not printed. Fax will not attempt to reprint the fax that generated the out of memory error until a POR is performed. Memory Full, cannot send faxes Fax server 'To Format' not set up After a start, there is no memory to do the fax job. Attempted fax is cancelled. Device is in Fax Server mode. The To format for the Fax Server setup is null. Analog receive still possible. Fax Station number not set up. Held jobs may not be restored This message is only posted once after the firmware has tried to restore all of the jobs on disk, regardless of the number of held jobs that were not restored. There are three versions of this IR, depending upon cause. IRHeldA occurs when any other condition occurs which stops the printer from restoring jobs from disk. These might include disk failure, user abort, etc. Diagnostics information 2-13