Netgear WG103 WG103 Reference Manual - Page 27
Con LAN Access and Set the Time, Configuration, System, Basic, General, Access Point name - default ip address
UPC - 606449062038
View all Netgear WG103 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
WG103 ProSafe 802.11g Wireless Access Point Reference Manual Configure LAN Access and Set the Time First, configure LAN access, and then set the time: 1. Log in to the wireless access point as described in "Log in to the Wireless Access Point" on page 2-4. The Web browser displays the General screen. (The full path to his screen is Configuration > System > Basic > General.) Figure 2-3 2. Specify the following fields, or use the default values, which work for most users and situations: • Access Point name. This unique name is the wireless access point NetBIOS name. The device can be accessed by entering either its name or IP address in the location bar of your browser.The default wireless access point name is on the bottom label of the wireless access point. You can modify the default name with a unique name up to 15 characters long. The default is netgearxxxxxx8, where xxxxx represents the first five digits of the last six digits of the wireless access point's MAC address.These five digits are followed by an eight (8). Note: The MAC address for the wireless access point always ends with a zero (0) but the NetBIOS name always ends with an eight (8). For example, if the MAC address 1234567890A0, then the NetBIOS name is netgear7890A8. • Country/Region. This is the region where the wireless access point can be used. It may not be legal to operate the wireless features of the wireless access point in a region other than one of those identified in this field. For products sold in the United States, the Country/Region field is preset according to regulatory requirements. For products sold outside the United States, a country domain must be selected. Basic Installation and Configuration 2-5 v1.0, February 2009