Netgear WG103 WG103 Reference Manual - Page 85
How to Con Repeater Mode
UPC - 606449062038
View all Netgear WG103 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 85 highlights
WG103 ProSafe 802.11g Wireless Access Point Reference Manual • Wireless stations will not be able to connect to any wireless access points in this configuration (see Figure 5-8 on page 5-11). If you require wireless stations to access any LAN segment, you can use additional wireless access points configured in regular access point mode to any LAN segment. Note: You can extend this multi-point bridging configuration by adding additional wireless access points that are configured in point-to-point mode for each additional LAN segment. Furthermore, you can extend the range of the wireless network with NETGEAR wireless antenna accessories. How to Configure Repeater Mode Select this option to enable the wireless access point to operate as a repeater only without communication with other wireless clients. All traffic is sent to the remote or "downstream" wireless access point. Up to four profiles can be configured. The following figure shows an example of a repeater mode configuration. Figure 5-9 Advanced Configuration v1.0, February 2009 5-13