Netgear WNDAP360 WNDAP360 Reference Manual - Page 13
Bottom Panel with Product Label - support
View all Netgear WNDAP360 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
ProSafe Dual Band Wireless-N Access Point WNDAP360 The rear panel functions of the ProSafe Dual Band Wireless-N Access Point WNDAP360 are described in the following list: 1. Reverse SMA connector for an optional 2.4-GHz antenna. 2. Factory default Reset button. Using a sharp object, press and hold this button for about 5 seconds to reset the wireless access point to factory defaults settings. All configuration settings are lost, and the default password is restored. For more information, see Restore the Wireless Access Point to the Factory Default Settings on page 66. 3. Console port for connecting to an optional console terminal. The port has an RJ-45 connector and supports the following settings: 9600 K default baud rate, (8) data bits, no (N) parity bit, and one (1) stop bit. 4. 10/100/1000BASE-T Gigabit Ethernet (RJ-45) port with Auto Uplink (Auto MDI-X) with IEEE 802.3af Power over Ethernet (PoE) support for connection to a switch or router. 5. Cable security lock receptacle for an optional lock. 6. Power socket for a 12 VDC, 1A power adapter. 7. Reverse SMA connector for an optional 2.4-GHz antenna. Bottom Panel with Product Label The product label on the bottom of the wireless access point's enclosure displays factory default settings, regulatory compliance, and other information: Figure 3. Introduction 13