Netgear WNDAP360 WNDAP360 Reference Manual - Page 82
Tagged VLAN, Management VLAN, To con STP and VLANs
View all Netgear WNDAP360 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 82 highlights
ProSafe Dual Band Wireless-N Access Point WNDAP360 • Tagged VLAN. When you clear the Untagged VLAN check box, the wireless access point tags all frames that are sent from its Ethernet interface. Only incoming frames that are tagged with known VLAN IDs are accepted. • Management VLAN. The management VLAN can be active only when the wireless access point functions as a point-to-point or point-to-multipoint bridge (see Configure Wireless Bridging on page 89). The management VLAN is used for managing traffic (Telnet, SNMP, and HTTP) to and from the wireless access point. Frames belonging to the management VLAN are not given any 802.1Q header when they are sent over the trunk. If a port is in a single VLAN, it can be untagged. However, if the port is a member of multiple VLANs, it needs to be tagged. To configure STP and VLANs: 1. Select Configuring > System > Advanced > General. The advanced General system settings screen displays: Figure 49. 2. Specify the settings as explained in the following table: Table 23. STP and VLAN Settings Field Description Spanning Tree Protocol Spanning Tree Protocol Select the Enable radio button to enable STP to prevent path redundancy. By default, the Disable radio button is selected. 802.1Q VLAN Untagged VLAN Select the Untagged VLAN check box to configure one VLAN as an untagged VLAN. By default, the Untagged VLAN check box is selected. Specify a VLAN ID. The default VLAN ID is 1. Advanced Configuration 82