Netgear WNDAP360 WNDAP360 Reference Manual - Page 71
Table 18., System Screen Fields, Management, ProSafe Dual Band Wireless-N Access Point WNDAP360 - wireless bridge
View all Netgear WNDAP360 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 71 highlights
ProSafe Dual Band Wireless-N Access Point WNDAP360 The following table explains the fields of the System screen: Table 18. System Screen Fields Field Description Access Point Information Access Point Name The NetBIOS name. For information about how to change the default name, see Configure Basic General System Settings and Time Settings on page 19. Ethernet MAC Address The MAC address of the wireless access point's Ethernet port. Wireless MAC Address The MAC address of the wireless access point's wireless card. Country/Region The country or region for which the wireless access point is licensed for use. For information about how to change the country or region, see Configure Basic General System Settings and Time Settings on page 19. Firmware Version Note: It might not be legal to operate this wireless access point in a country or region other than one of those identified in this field. The version of the firmware that is currently installed. Current Time The current time. For information about how to change the time settings, see Configure Basic General System Settings and Time Settings on page 19. Current IP Settings For information about how to change any of these IP settings, see Configure IP Settings and Optional DHCP Server Settings on page 21. IP Address The IP address of the wireless access point. Subnet Mask Default Gateway The subnet mask for the wireless access point. The default gateway for the wireless access point communication. DHCP Client Enabled indicates that the current IP address was obtained from a DHCP server on your LAN network. Disabled indicates a static IP configuration. Current Wireless Settings for 802.11n/g Access Point Mode The operating mode of the wireless access point. One of the following modes is indicated: • Access Point • Point-to-Point Bridge • Point-to-Point Bridge with Access Point • Multi-Point Bridge with/without client association For information about how to change the mode, see Configure Wireless Bridging on page 89. Channel / Frequency The channel the wireless port is using. For information about how to change the channel and frequency, see Configure 802.11b/bg/ng Wireless Settings on page 23. Rogue AP Detection Enabled indicates that rogue AP detection is enabled; Disabled indicates that it is not. Management 71