Pioneer SC-35 Owner's Manual - Page 100
Programming a Multi operation or a shutdown sequence, Using multi operations, Using System off,
UPC - 884938108751
View all Pioneer SC-35 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 100 highlights
10 Controlling the rest of your system (In case of SC-35) Programming a Multi operation or a shutdown sequence 1 Press and hold R.SETUP, then press "3" for three seconds. The LED flashes continuously. • To cancel the preset setup mode press R.SETUP. 2 Press the input function button (or SOURCE button). For Multi operations, press the input function you wish to program (for example, if you want to start the sequence by switching on your DVD player, press DVD).1 For System off, press the SOURCE button. The LED blinks twice and flashes continuously. 3 If necessary, press the input function button for the component whose command you want to input. This is only necessary if the command is for a new component (input function). 4 Select the button for the command you want to input. The LED blinks once and flashes continuously. • You don't need to program the receiver to switch on or off. This is done automatically. With Pioneer components, you don't need to program the power to switch off in a shutdown sequence (except DVD recorders). 5 Repeat steps 3 to 4 to program a sequence of up to five commands. If you press R.SETUP before programming is completed, commands programmed up to that point will be stored. 6 Press R.SETUP to exit the programming mode. Using System off 1 Press MULTI OPERATION. The LED flashes continuously. 2 Within five seconds, press SOURCE. The command sequence you programmed will run, then all Pioneer components will switch off2, followed by this receiver (switch of all the zones becomes off). Erasing the settings for the multi-operation This erases all the settings programmed in the remote control for the multi-operation. 1 Press and hold R.SETUP, then press "8" for three seconds. The LED flashes continuously. • To cancel the preset setup mode press R.SETUP. 2 Press the input function button containing the program you want to cancel or the SOURCE button for three seconds. If the LED lights for one second, the erasing has been successfully completed. Using multi operations 1 Press MULTI OPERATION. The LED flashes continuously. 2 Within five seconds, press an input function button that has been set up with a multi operation. The receiver switches on (if it was in standby) and the programmed multi operation is performed automatically. 100 En Note 1 With Multi operation, the HDMI and TV CTRL settings cannot be made. For other settable input functions, see Setting the remote to control other components on page 97. 2 In order to avoid accidently switching off a DVD recorder that is currently recording, no DVD recorder power off codes are sent.