Pioneer SC-35 Owner's Manual - Page 83

Controlling the rest of your system (In case of SC-37) 10 Chapter 10: Controlling the rest of your system (In case of SC-37) Important • This section includes explanations for the SC-37's remote control. For instructions for the SC-35's remote control, see Controlling the rest of your system (In case of SC-35) on page 96. About the Remote Setup menu The Remote Setup mode is set by pressing the HOME MENU button while pressing MULTI OPERATION. The different items on the Remote Setup menu are described below. For their setting procedures, refer to the explanations for the respective items. Setting What it does PRESET RECALL Preset codes can be set for the various input functions. The remote control codes of a number of other devices (including products of other brands) are preset in the remote control to allow these devices to be operated. See "Selecting preset codes directly" on page 84. CODE If the desired operations cannot be performed LEARNING even though you have set the preset codes, the remote control signals of other devices can be learned directly. See "Programming signals from other remote controls" on page 85. MULTI OPERATE A series of the remote control operations for starting listening or viewing can be programmed. Multiple remote control codes can be set for the different input functions. See "Multi Operation and System Off" on page 87. SYSTEM OFF This is a function for automatically turning off the power of devices connected to the receiver. Multiple remote control codes can be set, as desired. See "Multi Operation and System Off" on page 87. DIRECT FUNC This is a setting for changing only the remote control unit's operation screen, without changing the receiver's input, when the remote control unit's input function buttons are pressed. This is convenient for using the remote control unit for devices not connected to the receiver. See "Direct function" on page 86. RENAME The names of the input function buttons displayed on the remote control unit can be changed as desired. See "Renaming input function names manually" on page 86. Setting What it does SYNC Input function names changed on the receiver can RENAMING be acquired by the remote control unit so that the names are the same on the remote control unit. See "Renaming input function names in synchrony with the receiver" on page 93. ERASE This function is used to erase remote control LEARNING codes that have been learned. Codes learned for the different input functions can be erased individually. See "Erasing one of the remote control button settings" on page 85. IR/RF SELECT This function is for selecting wireless (RF) or infrared (IR) as the remote control operating mode for the different devices. See Operating this receiver by RF communications and Operating other components by RF communications on page 92 OPERATION The remote control unit's operation screen MODE switches automatically when the receiver's input is switched (This is only valid when the operation selector switch is set to SOURCE). See "Setting the remote control operation mode" on page 94. KEY RESET This is a function for resetting preset codes that have been set. Key resetting can be done for individual input functions. See "Resetting the input assignment of one of the input function buttons" on page 86. ALL RESET This is a function for resetting all remote control unit settings you have made to the defaults set upon shipment from the factory. See "Resetting the remote control settings" on page 86. READ The preset codes set for the different input PRESET ID functions can be checked. See "Confirming preset codes" on page 86. CHANGE RC MODE If you have multiple Pioneer receivers, amplifiers, etc., this setting can be used to prevent other units from operating simultaneously when the remote control unit is operated. See "Operating multiple receivers" on page 84. EXIT SETUP Exits the setup menu. Note • You can cancel or exit any of the steps by press and hold MULTI OPERATION for a couple of seconds. To go back a step, press RETURN. • After one minute of inactivity, the remote automatically exits the operation. 83 En