Pioneer SC-35 Owner's Manual - Page 128
Remote control, Web Control, Power, CONTROL IN, OPTION 1, Network Standby, Network Setup
UPC - 884938108751
View all Pioneer SC-35 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 128 highlights
13 Additional information Symptom Remedy The power turns off • See the Power section (page 122). automatically and some indicator flashes, or some indicator flashes and the power does not turn on. Remote control Symptom Remedy Cannot be remote controlled. • Set the remote control unit's remote control mode so that it matches the setting on the main unit (see Operating multiple receivers on page 84 (SC-37)/page 96 (SC-35)). • Check whether the receiver's remote control mode is properly set (see Remote Control Mode Setup on page 119). • Try replacing the batteries in the remote control (see Loading the batteries on page 10). • Be sure to operate within 7 m (23 feet) and a 30º angle of the remote sensor on the front panel (see Operating range of remote control unit on page 11). • Check that there are no obstacles between the receiver and the remote control. • Make sure that there is no fluorescent or other strong light shining on to the remote sensor. • Check the connections of the CONTROL IN jacks (see Operating other Pioneer components with this unit's sensor on page 41). SC-37 only: Input does not • Sirius and XM operations can no longer be performed if other preset codes are assigned to the switch to Sirius or XM when OPTION 1 (Sirius) or OPTION 2 (XM) button. In this case, reset the OPTION 1 or OPTION 2 button OPTION 1 or OPTION 2 button (see Resetting the input assignment of one of the input function buttons on page 86). is pressed. SC-37 only: Receiver or other components cannot be operated by RF two-way communications. • There may be radio interference with other devices. Try increasing the distance from microwave ovens, devices on a wireless LAN, other wireless devices, etc. (see Precautions when using the OmniDirectional RF Remote Control on page 94). • Try replacing the batteries in the remote control (see Loading the batteries on page 10). • If the RF adapter's LED is off, the RF adapter may not be properly connected to the receiver. Check whether the RF adapter is properly connected to the receiver (see Connecting the RF adapter (SC-37 only) on page 21). • The devices may no longer be properly paired. Pair them again (see Pairing the RF adapter and remote control on page 92). • When the remote control or main unit are reset, the RF communications function is also reset. Make the settings again (see Using the RF communications function on page 91). SC-37 only: The remote control • Flickering may occur when the remaining battery power is low. Replace the batteries with new display flickers. ones (see Loading the batteries on page 10). Other components can't be operated with the system remote. • If the battery ran down, the preset codes may have been cleared. Re-enter the preset codes. • The preset code may be incorrect. Redo the procedure for entering preset codes. • When commands from the remote control units of other devices are registered using the learning function, in some cases they may not be learned properly. In this case, register the commands again using the learning function (see Programming signals from other remote controls on page 85 (SC-37) / page 97 (SC-35)). If they still do not work, they may be in a special format that cannot be registered on this receiver's remote control. Operate the device using another remote control. Web Control Symptoms Top Menu screen is not displayed on browser. Causes This receiver's IP address has not been entered into the browser correctly. Remedies Check the receiver's IP address and enter it correctly in the browser (page 117). Receiver cannot be operated JavaScript is disabled on the internet browser. from browser. The browser is not compatible with JavaScript. Receiver's power does not turn on when the power is turned on using the Web Control function. Network Standby at Network Setup is set to OFF. Enable JavaScript. Use an internet browser that is compatible with JavaScript. Set Network Standby at Network Setup to ON (page 118). 128 En