Pioneer SC-35 Owner's Manual - Page 82
Resetting the system, Default system settings - factory reset
UPC - 884938108751
View all Pioneer SC-35 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 82 highlights
09 Using other functions Resetting the system Use this procedure to reset all the receiver's settings to the factory default. Use the front panel controls to do this. Set MULTI-ZONE to OFF. • Disconnect the iPod and USB memory device from the receiver beforehand. 1 Switch the receiver into standby. 2 While holding down ENTER on the front panel, press STANDBY/ON. The display shows RESET NO . 3 Select 'RESET' using PRESET /, then press ENTER on the front panel. The display shows RESET? OK. 4 Press ENTER to confirm. OK appears in the display to indicate that the receiver has been reset to the factory default settings. • Note that all settings will be saved, even if the receiver is unplugged. Default system settings Setting Default Digital Video Conversion ON SPEAKERS A Speaker System Normal (SB/FH) Speaker Setting Front SMALL Center SMALL FH/FW SMALL Surr SMALL SB SMALLx2 SW YES Surround Position IN REAR Crossover 80 Hz X-Curve OFF THX Audio Setting 4 ft< DIMMER Brightest Network Standby OFF Inputs See Input function default and possible settings on page 46. HDMI HDMI Audio Amp HDMI output HDMI OUT ALL Control ON Control Mode ALL DIsplay Power Off YES Setting Default DSP Power On Level LAST Volume Limit OFF Mute Level FULL Phase Control ON Sound Retriever iPod/USB, HOME ON MEDIA GALLERY (SC37 only), INTERNET RADIO (SC-35 only), ADAPTER PORT function Other functions OFF Sound Delay 0.0 frame Dual Mono CH1 DRC AUTO SACD Gain 0 dB LFE Attenuate 0 dB Auto delay OFF Digital Safety OFF Effect Level ExtendedStereo 90 Other modes 50 2 PL II Music Options Center Width 3 Dimension 0 Panorama OFF Neo:6 Options Center Image Neo:6 MUSIC: 3 Neo:6 CINEMA: 10 All Inputs Listening Mode (2 ch/multi ch) AUTO SURROUND Listening Mode (HP) STEREO See also Setting the Audio options on page 76 for other default DSP settings. MCACC MCACC Position Memory M1: MEMORY 1 Channel Level (M1 to M6) 0.0 dB Speaker Distance (M1 to M6) 10.00 ft Standing Wave (M1 to M6) ATT of all channels/ 0.0 dB filters SWch Wide Trim 0.0 dB EQ Data (M1 to M6) All channels/bands 0.0 dB EQ Wide Trim 0.0 dB 82 En