Pioneer SC-35 Owner's Manual - Page 96

10 Controlling the rest of your system (In case of SC-35) Controlling the rest of your system (In case of SC-35) Important • This section includes explanations for the SC-35's remote control. For instructions for the SC-37's remote control, see Controlling the rest of your system (In case of SC-37) on page 83. About the Remote Setup menu The Remote Setup mode is set by pressing the number button while pressing R.SETUP. The different items on the Remote Setup menu are described below. For their setting procedures, refer to the explanations for the respective items. Setting What it does Preset recall Preset codes can be set for the various input functions. The remote control codes of a number of other devices (including products of other brands) are preset in the remote control to allow these devices to be operated. See "Selecting preset codes directly" on page 97. Code learning If the desired operations cannot be performed even though you have set the preset codes, the remote control signals of other devices can be learned directly. See "Programming signals from other remote controls" on page 97. Multi operation A series of the remote control operations for starting listening or viewing can be programmed. Multiple remote control codes can be set for the different input functions. See "Multi operation and System off" on page 99. System off This is a function for automatically turning off the power of devices connected to the receiver. Multiple remote control codes can be set, as desired. See "Multi operation and System off" on page 99. Direct function This is a setting for changing only the remote control unit's operation screen, without changing the receiver's input, when the remote control unit's input function buttons are pressed. This is convenient for using the remote control unit for devices not connected to the receiver. See "Direct function" on page 98. Erase learning This function is used to erase remote control codes that have been learned. Codes learned for the different input functions can be erased individually. See "Erasing one of the remote control button settings" on page 98. Back light The backlight lighting pattern can be selected from among four modes, in consideration of convenience and battery service life. See "Setting the backlight mode" on page 99. Setting What it does Reset function This is a function for resetting preset codes that have been set. Key resetting can be done for individual input functions. See "Erasing all learnt settings that are in one input function" on page 98. All reset This is a function for resetting all remote control unit settings you have made to the defaults set upon shipment from the factory. See "Resetting the remote control settings" on page 101. Change RC If you have multiple Pioneer receivers, amplifiers, mode etc., this setting can be used to prevent other units from operating simultaneously when the remote control unit is operated. See "Operating multiple receivers" on page 96. Note • You can cancel or exit any of the steps by pressing R.SETUP. • After one minute of inactivity, the remote automatically exits the operation. Operating multiple receivers Up to four receivers can be operated discretely using this receiver's remote control when using multiple receivers, provided they are of the same model as this receiver. The receiver to be operated is switched by inputting the preset code to set the remote control setting. • Set the remote modes on the receivers before using this function (see Remote Control Mode Setup on page 119). 1 Press and hold R.SETUP, then press "4" for three seconds. The LED flashes continuously. • To cancel the preset setup mode press R.SETUP. 2 Press the number button for the receiver ("Receiver 1" to "Receiver 4") you wish to operate. For example, to operate "Receiver 2", press "2". If the LED lights for one second, the setting has been successfully completed. When the preset code is input, the LED flashes three times to indicate that the setting has failed. 96 En